full
border
#666666
https://reliancedetection.com/wp/wp-content/themes/smartbox-installable/
https://reliancedetection.com/
#0068b3
style4

FAQs: RSA-500-100 Wireless Wall Switch

How do I connect the Wireless HVAC Setback unit to the RS-360?

At the Receiver terminals labeled ENOCEAN INTERFACE, place the Red wire to +16V (Pin 1), the Black wire to GROUND (Pin 2), a Yellow wire to WALL SWITCH (Pin 3), and a Yellow wire to GROUND (Pin 4). The Yellow wire placement does not matter as long as one is on Pin 3 and one is on Pin 4. Be sure the unit is completely powered down and off before attempting any electrical wiring. All electrical work should follow local electrical and safety codes.

Connecting the wireless water switch to the RS-360

How do you pair the rocker pad and the setback unit?

Access Basic Setup mode by pressing both buttons on the HVAC Setback unit for 2 seconds as shown below:

Pairing step 1

NOTE: By default, the Accept Link option in the Linking menu is selected. Once activated, this option stays active for two minutes to provide time to link multiple devices.

The device is ready to accept links shown below:

Pairing step 2

For the transmitter to be linked, click the top button on the Rocker Pad 3 times quickly. If device links successfully, the Set LED displays solid green for 3 seconds as shown below:

Pairing step 3

Then, ready to accept new links looks like this:

Pairing step 4

Only use this if you have bought multiple rocker pads and wish to link them all to the same setback unit. To exit mode and return to normal operation, press and hold both buttons for 2 seconds.

Can I unlink the Setback unit and the Rocker Pad?

Yes. To access Basic Setup mode by pressing both buttons on the setback unit for 2 seconds as shown below:

Unpair step 1

Click the “Set” (right) button 3 times to enable the “Remove Link” option. Ready to remove links shown below:

Unpair step 2

For the transmitter to be un-linked, click the top button on the Rocker Pad 3 times quickly. The Set (right) LED will turn red briefly to indicate the link was successfully removed.

To exit mode and return to normal operation, press and hold both buttons for 2 seconds.

I tried to pair the units but it is not working. Any ideas?

Check the following items:

  1. The Setback unit has to be wired in to the RS-360 and the RS-360 has to be powered by wall power and battery before any pairing can be done.
  2. Remove power from all units, reapply power and wait 5 seconds in between steps when trying to pair. Sometimes giving the commands too fast trips the unit up.
  3. Remove the wiring and then after 15 seconds hook the wiring back in. Sometimes a faulty connection is to blame. (Make sure the Receiver is powered down and off during this step).

How far can I put the Rocker Pad from the Receiver?

A maximum distance of 80 feet (25 meters).

Can I do the install of the Wireless wall switch myself?

Installation should be done following all local electrical and safety codes. We recommend a licensed electrician perform all electrical work.

default
Loading posts...
link_magnifier
#ececec
on
fadeInDown
loading
#ececec
off